Schlage BE479AA V CEN 619 Installation Guide download pdf (Page 12)

12

ENGLISH

TROUBLESHOOTING

Problem Sounds Lights Solution

I forgot my

Programming

Code.*

— — Check the front of this guide or the

back of the Alarm Assembly for

default Programming Code.

If needed, restore lock to factory

settings. See Factory Default Reset

on page 14.

I need to delete an

access code that I

don’t remember.*

— — Delete all access codes. Then add all

needed access codes back into the

lock. See Delete ALL Access Codes

on page 8.

Cannot add a new

access code.*

— Yellow

dot

ﬂashing

1 was not pressed aer entering

Programming Mode.

2 beeps

2 Red

30 access codes already exist. Delete

an access code before adding a new

one. See Deleting Access Codes on

page 8.

Second access code entry did not

match ﬁrst access code entry.

The new access code matches

the ﬁrst 4 - 6 digits of the existing

Programming Code.

Cannot delete an

access code. *

— Yellow

dot

ﬂashing

2 was not pressed aer entering

Programming Mode.

2 beeps

2 Red

First access code entered did not

match any current access code.

Second access code entered did not

match ﬁrst access code entered.

Cannot change

Programming

Code.*

— Yellow

dot

ﬂashing

3 was not pressed aer entering

Programming Mode.

2 beeps

2 Red

Second Programming Code entered

did not match ﬁrst Programming

Code entered.

First 4 - 6 digits of new Programming

Code match an existing access code.

Cannot delete all

access codes.*

— Yellow

dot

ﬂashing

6 was not pressed aer entering

Programming Mode.

The 2nd Programming Code entered

was not valid.

Access code does

not unlock lock.

1 beep

1 Red

Access code entered is not a valid

access code.

1 2 ... 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments